低溫廢水回收設備的維護方法您知道包含哪些內容呢？這一問題在設備使用期間需要多加了解的，不然非常容易會因?yàn)槟骋患?xì)節沒做好而導致問題存在。

What do you know about the maintenance methods of low-temperature wastewater recovery equipment? This problem needs to be understood more during the use of the equipment, otherwise it is very easy to cause problems because some details are not well done.

一、每天上班時檢查生活低溫廢水回收設備進污水泵和回流泵是否結冰，包括水泵的潤滑加油，填料的松緊，底閥的密封比空壓機的加注機油等。

1、 Check whether the sewage pump and reflux pump of the domestic low-temperature wastewater recovery equipment are frozen at work every day, including the lubrication and oiling of the water pump, the tightness of the packing, the sealing of the bottom valve and the oiling of the air compressor.

二、檢查空壓機空氣濾水伐有無上凍，以判斷空壓機正常運轉，有無雜聲及發熱現象。

2、 Check whether the air filter valve of the air compressor is frozen to judge whether the air compressor operates normally and whether there is noise and heat.

三、檢查刮渣機的傳動部分及刮板，在寒冷狀態下是否變硬折斷，以免影響使用。

3、 Check whether the drive part and scraper of the slag scraper are hard and broken in cold state, so as not to affect the use.

四、注意混凝劑攪拌儲存罐避免結冰，并經常做小樣試驗。

4、 Attention shall be paid to avoid freezing in coagulant mixing storage tank, and sample test shall be conducted frequently.

五、對各設備閥門管路進行檢查以免閥門管路有堵賽、并按要求分別置于“開”或“關”的位置。

5、 Check the valves and pipelines of each equipment to avoid blockage of valves and pipelines, and place them at the "on" or "off" positions as required.

六、停機時須將水放干凈，以免發生結冰堵塞。

6、 During shutdown, the water must be drained to avoid icing and blockage.

低溫廢水回收設備的維護方法從6點講解完畢，您對此有什么不懂得地方可以隨時來我們網站cmicroentropy.com進行聯系了解！

The maintenance method of low-temperature wastewater recovery equipment was explained at 6 o'clock. If you don't know anything about it, you can contact us at cmicroentropy.com at any time!