1在清洗過程中，要注意很多地方，禁止導電液體（如水）從超聲波控制柜頂部的進氣口進入。否則會對清洗機的電路系統造成嚴重?fù)p壞。

1. During cleaning, pay attention to many places. Conductive liquid (such as water) is not allowed to enter from the air inlet on the top of the ultrasonic control cabinet. Otherwise, it will cause serious damage to the circuit system of the cleaning machine.

2不使用時，保持機器清潔并關閉電源。

2 keep the machine clean and turn off the power when not in use.

3我們的機器不是耐碰撞的產品，所以在使用時要避免碰撞或劇烈振動。

Our machine is not a collision resistant product, so we should avoid collision or violent vibration when using it.

4我們應該讓機器遠離高溫?zé)嵩础?/p>

We should keep the machine away from high-temperature heat sources.

5同時，我們應該避免把機器放在潮濕的環境中。

At the same time, we should avoid putting the machine in a humid environment.

6機器的連續工作時間不得超過4小時。例如，關閉超聲波按鈕，讓散熱器風扇繼續工作。當超聲波清洗未開始時，應連續冷卻超聲波控制柜2-3分鐘。

6 the continuous working time of the machine shall not exceed 4 hours. For example, turn off the ultrasonic button and let the radiator fan continue to work. When ultrasonic cleaning is not started, the ultrasonic control cabinet shall be continuously cooled for 2-3 minutes.

7對于長時間運行的清洗機，關機前應將電源旋鈕調0，工作3-6分鐘后關閉風扇，使電源內部熱量散失。

7 for the cleaning machine running for a long time, adjust the power knob to 0 before shutdown, and turn off the fan after working for 3-6 minutes to dissipate the heat inside the power supply.

8清洗液應及時沉淀、過濾或更換，確保清洗效果。

8. The cleaning solution shall be precipitated, filtered or replaced in time to ensure the cleaning effect.

以上的信息就是超聲波清洗機生產廠家給小編提供的知識分享，更多的精彩內容請點擊我們的網站：http://cmicroentropy.com，我們后續會有更多的內容等您查看

The above information is the knowledge sharing provided by the manufacturer of ultrasonic cleaning machine to Xiaobian. For more wonderful contents, please click our website: http://cmicroentropy.com , we will have more content for you to check later